[  300.584196] PM: suspend entry (s2idle)

[  300.588453] Filesystems sync: 0.003 seconds

[  300.593360] Freezing user space processes

[  300.595045] Freezing user space processes completed (elapsed 0.001 seconds)

[  300.595054] OOM killer disabled.

[  300.595056] Freezing remaining freezable tasks

[  300.596175] Freezing remaining freezable tasks completed (elapsed 0.001 seconds)

[  300.596179] printk: Suspending console(s) (use no_console_suspend to debug)

[  301.977170] qcom-pcie 1c10000.pcie: Device not found

[  302.293097] qcom-pcie 1c00000.pcie: PCIe Gen.3 x1 link up

[  302.295996] geni_i2c 890000.i2c: Unbalanced pm_runtime_enable!

[  302.299205] geni_i2c a90000.i2c: Unbalanced pm_runtime_enable!

[  302.299231] geni_i2c 894000.i2c: Unbalanced pm_runtime_enable!

[  302.340726] ath11k_pci 0000:01:00.0: htt event 5 not handled

[  302.378710] arm-smmu 15000000.iommu: Unhandled context fault: fsr=0x402, iova=0x5a7dcd100, fsynr=0x220011, cbfrsynra=0xa0, cb=10

[  302.378722] arm-smmu 15000000.iommu: FSR    = 00000402 [Format=2 TF], SID=0xa0

[  302.378726] arm-smmu 15000000.iommu: FSYNR0 = 00220011 [S1CBNDX=34 WNR PLVL=1]

[  302.393318] xhci-hcd xhci-hcd.0.auto: WARNING: Host System Error

[  303.484760] onboard-usb-dev 2-1: device not accepting address 2, error -108

[  304.084747] onboard-usb-dev 2-1: device not accepting address 2, error -108

[  304.684685] onboard-usb-dev 2-1: device not accepting address 2, error -108

[  305.284975] onboard-usb-dev 2-1: device not accepting address 2, error -108

[  305.444596] OOM killer enabled.

[  305.444599] Restarting tasks: Starting

[  305.445108] onboard-usb-dev 1-1: USB disconnect, device number 2

[  305.445133] Restarting tasks: Done

[  305.445146] efivarfs: resyncing variable state

[  305.445565] onboard-usb-dev 2-1: USB disconnect, device number 2

[  305.451994] usb usb2-port1: couldn't allocate usb_device

[  305.458205] usb usb1-port1: couldn't allocate usb_device

[  305.560468] efivarfs: finished resyncing variable state

[  305.561025] PM: suspend exit

[  305.569537] wlp1s0: deauthenticating from f0:61:c0:fb:1a:90 by local choice (Reason: 3=DEAUTH_LEAVING)

[  305.662457] qcom-ethqos 23040000.ethernet end0: Register MEM_TYPE_PAGE_POOL RxQ-0

[  305.662861] qcom-ethqos 23040000.ethernet end0: Register MEM_TYPE_PAGE_POOL RxQ-1

[  305.663307] qcom-ethqos 23040000.ethernet end0: Register MEM_TYPE_PAGE_POOL RxQ-2

[  305.663782] qcom-ethqos 23040000.ethernet end0: Register MEM_TYPE_PAGE_POOL RxQ-3

[  305.807734] qcom-ethqos 23040000.ethernet end0: PHY [stmmac-0:1c] driver [Qualcomm QCA8081] (irq=POLL)

[  305.820192] qcom-ethqos 23040000.ethernet end0: Enabling Safety Features

[  305.820290] qcom-ethqos 23040000.ethernet end0: IEEE 1588-2008 Advanced Timestamp supported

[  305.820439] qcom-ethqos 23040000.ethernet end0: registered PTP clock

[  305.820444] qcom-ethqos 23040000.ethernet end0: configuring for phy/2500base-x link mode

[  313.351901] wlp1s0: authenticate with f0:61:c0:fb:1a:90 (local address=04:68:74:b7:1a:db)

[  313.351912] wlp1s0: send auth to f0:61:c0:fb:1a:90 (try 1/3)

[  313.356395] wlp1s0: authenticated

[  313.362156] wlp1s0: associate with f0:61:c0:fb:1a:90 (try 1/3)

[  313.367821] wlp1s0: RX AssocResp from f0:61:c0:fb:1a:90 (capab=0x411 status=0 aid=25)

[  313.416718] wlp1s0: associated 