[  220.074992] PM: suspend entry (s2idle)

[  220.081877] Filesystems sync: 0.006 seconds

[  220.089352] Freezing user space processes

[  222.156137] qcom-apm-audio-pkt gprsvc:service:2:1: CMD timeout for [1001013] opcode

[  222.167994] Freezing user space processes completed (elapsed 2.079 seconds)

[  222.168010] OOM killer disabled.

[  222.168012] Freezing remaining freezable tasks

[  222.170837] Freezing remaining freezable tasks completed (elapsed 0.002 seconds)

[  222.170843] printk: Suspending console(s) (use no_console_suspend to debug)

[  223.647699] qcom-pcie 1c10000.pcie: Device not found

[  223.963032] qcom-pcie 1c00000.pcie: PCIe Gen.3 x1 link up

[  223.973379] geni_i2c 890000.i2c: Unbalanced pm_runtime_enable!

[  223.977802] geni_i2c 894000.i2c: Unbalanced pm_runtime_enable!

[  223.977820] geni_i2c a90000.i2c: Unbalanced pm_runtime_enable!

[  224.049914] ath11k_pci 0000:01:00.0: htt event 5 not handled

[  224.089708] arm-smmu 15000000.iommu: Unhandled context fault: fsr=0x402, iova=0x2f7bf2ff0, fsynr=0x500011, cbfrsynra=0xa0, cb=10

[  224.089725] arm-smmu 15000000.iommu: FSR    = 00000402 [Format=2 TF], SID=0xa0

[  224.089730] arm-smmu 15000000.iommu: FSYNR0 = 00500011 [S1CBNDX=80 WNR PLVL=1]

[  224.103742] xhci-hcd xhci-hcd.0.auto: WARNING: Host System Error

[  225.175158] onboard-usb-dev 2-1: device not accepting address 2, error -108

[  225.775056] onboard-usb-dev 2-1: device not accepting address 2, error -108

[  226.374988] onboard-usb-dev 2-1: device not accepting address 2, error -108

[  226.974802] onboard-usb-dev 2-1: device not accepting address 2, error -108

[  227.152081] OOM killer enabled.

[  227.152087] Restarting tasks: Starting

[  227.152705] Restarting tasks: Done

[  227.152722] efivarfs: resyncing variable state

[  227.152943] onboard-usb-dev 2-1: USB disconnect, device number 2

[  227.154055] onboard-usb-dev 1-1: USB disconnect, device number 2

[  227.158435] usb usb2-port1: couldn't allocate usb_device

[  227.164074] usb usb1-port1: couldn't allocate usb_device

[  227.305328] efivarfs: finished resyncing variable state

[  227.306007] PM: suspend exit

[  227.319287] wlp1s0: deauthenticating from f0:61:c0:fb:79:d0 by local choice (Reason: 3=DEAUTH_LEAVING)

[  227.482803] qcom-ethqos 23040000.ethernet end0: Register MEM_TYPE_PAGE_POOL RxQ-0

[  227.483266] qcom-ethqos 23040000.ethernet end0: Register MEM_TYPE_PAGE_POOL RxQ-1

[  227.483709] qcom-ethqos 23040000.ethernet end0: Register MEM_TYPE_PAGE_POOL RxQ-2

[  227.484091] qcom-ethqos 23040000.ethernet end0: Register MEM_TYPE_PAGE_POOL RxQ-3

[  227.605358] qcom-ethqos 23040000.ethernet end0: PHY [stmmac-0:1c] driver [Qualcomm QCA8081] (irq=POLL)

[  227.617987] qcom-ethqos 23040000.ethernet end0: Enabling Safety Features

[  227.618150] qcom-ethqos 23040000.ethernet end0: IEEE 1588-2008 Advanced Timestamp supported

[  227.618344] qcom-ethqos 23040000.ethernet end0: registered PTP clock

[  227.618349] qcom-ethqos 23040000.ethernet end0: configuring for phy/2500base-x link mode

[  235.628045] wlp1s0: authenticate with f0:61:c0:fb:79:d0 (local address=04:68:74:b7:1a:47)

[  235.628064] wlp1s0: send auth to f0:61:c0:fb:79:d0 (try 1/3)

[  235.633966] wlp1s0: authenticated

[  235.636376] wlp1s0: associate with f0:61:c0:fb:79:d0 (try 1/3)

[  235.642983] wlp1s0: RX AssocResp from f0:61:c0:fb:79:d0 (capab=0x411 status=0 aid=8)

[  235.684670] wlp1s0: associated

[  250.841159] qcom-apm-audio-pkt gprsvc:service:2:1: CMD timeout for [1001013] opcode

[  273.380174] qcom-apm-audio-pkt gprsvc:service:2:1: CMD timeout for [1001013] opcode 