[  848.631756] PM: suspend entry (s2idle)

[  848.636241] Filesystems sync: 0.004 seconds

[  848.642387] Freezing user space processes

[  853.038442] qcom-apm-audio-pkt gprsvc:service:2:1: CMD timeout for [1001013] opcode

[  853.050115] Freezing user space processes completed (elapsed 4.407 seconds)

[  853.050131] OOM killer disabled.

[  853.050134] Freezing remaining freezable tasks

[  853.053340] Freezing remaining freezable tasks completed (elapsed 0.003 seconds)

[  853.053346] printk: Suspending console(s) (use no_console_suspend to debug)

[  854.478355] qcom-pcie 1c10000.pcie: Device not found

[  854.795030] qcom-pcie 1c00000.pcie: PCIe Gen.3 x1 link up

[  854.799679] geni_i2c 890000.i2c: Unbalanced pm_runtime_enable!

[  854.807350] geni_i2c a90000.i2c: Unbalanced pm_runtime_enable!

[  854.807462] geni_i2c 894000.i2c: Unbalanced pm_runtime_enable!

[  854.904302] ath11k_pci 0000:01:00.0: htt event 5 not handled

[  854.916197] arm-smmu 15000000.iommu: Unhandled context fault: fsr=0x402, iova=0xe4180a640, fsynr=0x11, cbfrsynra=0xa0, cb=10

[  854.916212] arm-smmu 15000000.iommu: FSR    = 00000402 [Format=2 TF], SID=0xa0

[  854.916216] arm-smmu 15000000.iommu: FSYNR0 = 00000011 [S1CBNDX=0 WNR PLVL=1]

[  854.930762] xhci-hcd xhci-hcd.0.auto: WARNING: Host Controller Error

[  856.026863] onboard-usb-dev 2-1: device not accepting address 2, error -108

[  856.626481] onboard-usb-dev 2-1: device not accepting address 2, error -108

[  857.227025] onboard-usb-dev 2-1: device not accepting address 2, error -108

[  857.827070] onboard-usb-dev 2-1: device not accepting address 2, error -108

[  857.995177] OOM killer enabled.

[  857.995183] Restarting tasks: Starting

[  857.995843] onboard-usb-dev 1-1: USB disconnect, device number 2

[  857.996595] Restarting tasks: Done

[  857.996620] onboard-usb-dev 2-1: USB disconnect, device number 2

[  857.996639] efivarfs: resyncing variable state

[  857.998075] usb usb1-port1: couldn't allocate usb_device

[  858.003611] usb usb2-port1: couldn't allocate usb_device

[  858.249969] efivarfs: finished resyncing variable state

[  858.253965] PM: suspend exit

[  858.269188] wlp1s0: deauthenticating from f0:61:c0:fb:79:d0 by local choice (Reason: 3=DEAUTH_LEAVING)

[  858.406384] qcom-ethqos 23040000.ethernet end0: Register MEM_TYPE_PAGE_POOL RxQ-0

[  858.406861] qcom-ethqos 23040000.ethernet end0: Register MEM_TYPE_PAGE_POOL RxQ-1

[  858.407364] qcom-ethqos 23040000.ethernet end0: Register MEM_TYPE_PAGE_POOL RxQ-2

[  858.407779] qcom-ethqos 23040000.ethernet end0: Register MEM_TYPE_PAGE_POOL RxQ-3

[  858.538369] qcom-ethqos 23040000.ethernet end0: PHY [stmmac-0:1c] driver [Qualcomm QCA8081] (irq=POLL)

[  858.550840] qcom-ethqos 23040000.ethernet end0: Enabling Safety Features

[  858.551036] qcom-ethqos 23040000.ethernet end0: IEEE 1588-2008 Advanced Timestamp supported

[  858.552999] qcom-ethqos 23040000.ethernet end0: registered PTP clock

[  858.553014] qcom-ethqos 23040000.ethernet end0: configuring for phy/2500base-x link mode

[  866.160135] wlp1s0: authenticate with f0:61:c0:fb:79:d0 (local address=04:68:74:b7:16:a7)

[  866.160153] wlp1s0: send auth to f0:61:c0:fb:79:d0 (try 1/3)

[  866.166785] wlp1s0: authenticated

[  866.167432] wlp1s0: associate with f0:61:c0:fb:79:d0 (try 1/3)

[  866.174868] wlp1s0: RX AssocResp from f0:61:c0:fb:79:d0 (capab=0x411 status=0 aid=7)

[  866.214382] wlp1s0: associated

[  881.628653] qcom-apm-audio-pkt gprsvc:service:2:1: CMD timeout for [1001013] opcode

[  904.146661] qcom-apm-audio-pkt gprsvc:service:2:1: CMD timeout for [1001013] opcode 