[  297.979127] PM: suspend entry (s2idle)

[  297.982726] Filesystems sync: 0.003 seconds

[  297.988099] Freezing user space processes

[  297.989696] Freezing user space processes completed (elapsed 0.001 seconds)

[  297.989703] OOM killer disabled.

[  297.989704] Freezing remaining freezable tasks

[  297.990806] Freezing remaining freezable tasks completed (elapsed 0.001 seconds)

[  297.990809] printk: Suspending console(s) (use no_console_suspend to debug)

[  299.352768] qcom-pcie 1c10000.pcie: Device not found

[  299.664478] qcom-pcie 1c00000.pcie: PCIe Gen.3 x1 link up

[  299.670194] geni_i2c 890000.i2c: Unbalanced pm_runtime_enable!

[  299.673137] geni_i2c a90000.i2c: Unbalanced pm_runtime_enable!

[  299.673161] geni_i2c 894000.i2c: Unbalanced pm_runtime_enable!

[  299.714715] ath11k_pci 0000:01:00.0: htt event 5 not handled

[  299.754622] arm-smmu 15000000.iommu: Unhandled context fault: fsr=0x402, iova=0xd036b9da0, fsynr=0x11, cbfrsynra=0xa0, cb=10

[  299.754634] arm-smmu 15000000.iommu: FSR    = 00000402 [Format=2 TF], SID=0xa0

[  299.754637] arm-smmu 15000000.iommu: FSYNR0 = 00000011 [S1CBNDX=0 WNR PLVL=1]

[  299.769078] xhci-hcd xhci-hcd.1.auto: WARNING: Host System Error

[  300.868415] onboard-usb-dev 2-1: device not accepting address 2, error -108

[  301.468693] onboard-usb-dev 2-1: device not accepting address 2, error -108

[  302.068433] onboard-usb-dev 2-1: device not accepting address 2, error -108

[  302.668672] onboard-usb-dev 2-1: device not accepting address 2, error -108

[  302.833335] OOM killer enabled.

[  302.833340] Restarting tasks: Starting

[  302.833608] onboard-usb-dev 2-1: USB disconnect, device number 2

[  302.833667] onboard-usb-dev 1-1: USB disconnect, device number 2

[  302.834709] usb usb2-port1: couldn't allocate usb_device

[  302.840550] Restarting tasks: Done

[  302.840562] efivarfs: resyncing variable state

[  302.842736] usb usb1-port1: couldn't allocate usb_device

[  302.958787] efivarfs: finished resyncing variable state

[  302.959380] PM: suspend exit

[  302.969984] wlp1s0: deauthenticating from f0:61:c0:fb:79:d0 by local choice (Reason: 3=DEAUTH_LEAVING)

[  303.097220] qcom-ethqos 23040000.ethernet end0: Register MEM_TYPE_PAGE_POOL RxQ-0

[  303.097622] qcom-ethqos 23040000.ethernet end0: Register MEM_TYPE_PAGE_POOL RxQ-1

[  303.098208] qcom-ethqos 23040000.ethernet end0: Register MEM_TYPE_PAGE_POOL RxQ-2

[  303.098781] qcom-ethqos 23040000.ethernet end0: Register MEM_TYPE_PAGE_POOL RxQ-3

[  303.239494] qcom-ethqos 23040000.ethernet end0: PHY [stmmac-0:1c] driver [Qualcomm QCA8081] (irq=POLL)

[  303.251923] qcom-ethqos 23040000.ethernet end0: Enabling Safety Features

[  303.252024] qcom-ethqos 23040000.ethernet end0: IEEE 1588-2008 Advanced Timestamp supported

[  303.252189] qcom-ethqos 23040000.ethernet end0: registered PTP clock

[  303.252194] qcom-ethqos 23040000.ethernet end0: configuring for phy/2500base-x link mode

[  311.094649] wlp1s0: authenticate with f0:61:c0:fb:79:d0 (local address=04:68:74:b7:16:a7)

[  311.094663] wlp1s0: send auth to f0:61:c0:fb:79:d0 (try 1/3)

[  311.099992] wlp1s0: authenticated

[  311.104293] wlp1s0: associate with f0:61:c0:fb:79:d0 (try 1/3)

[  311.112568] wlp1s0: RX AssocResp from f0:61:c0:fb:79:d0 (capab=0x411 status=0 aid=10)

[  311.153800] wlp1s0: associated 