[  219.477893] PM: suspend entry (s2idle)

[  219.480628] Filesystems sync: 0.002 seconds

[  219.487376] Freezing user space processes

[  222.169607] qcom-apm-audio-pkt gprsvc:service:2:1: CMD timeout for [1001013] opcode

[  222.181840] Freezing user space processes completed (elapsed 2.694 seconds)

[  222.181858] OOM killer disabled.

[  222.181860] Freezing remaining freezable tasks

[  222.184731] Freezing remaining freezable tasks completed (elapsed 0.002 seconds)

[  222.184737] printk: Suspending console(s) (use no_console_suspend to debug)

[  223.637133] qcom-pcie 1c10000.pcie: Device not found

[  223.953724] qcom-pcie 1c00000.pcie: PCIe Gen.3 x1 link up

[  223.963565] geni_i2c 890000.i2c: Unbalanced pm_runtime_enable!

[  223.967661] geni_i2c a90000.i2c: Unbalanced pm_runtime_enable!

[  223.967691] geni_i2c 894000.i2c: Unbalanced pm_runtime_enable!

[  224.049553] ath11k_pci 0000:01:00.0: htt event 5 not handled

[  224.091622] arm-smmu 15000000.iommu: Unhandled context fault: fsr=0x402, iova=0x1a931b90, fsynr=0x150011, cbfrsynra=0xa0, cb=10

[  224.091638] arm-smmu 15000000.iommu: FSR    = 00000402 [Format=2 TF], SID=0xa0

[  224.091643] arm-smmu 15000000.iommu: FSYNR0 = 00150011 [S1CBNDX=21 WNR PLVL=1]

[  224.105744] xhci-hcd xhci-hcd.0.auto: WARNING: Host System Error

[  225.188696] onboard-usb-dev 2-1: device not accepting address 2, error -108

[  225.789245] onboard-usb-dev 2-1: device not accepting address 2, error -108

[  226.388966] onboard-usb-dev 2-1: device not accepting address 2, error -108

[  226.988979] onboard-usb-dev 2-1: device not accepting address 2, error -108

[  227.177092] OOM killer enabled.

[  227.177098] Restarting tasks: Starting

[  227.177902] onboard-usb-dev 2-1: USB disconnect, device number 2

[  227.178109] onboard-usb-dev 1-1: USB disconnect, device number 2

[  227.178179] Restarting tasks: Done

[  227.178190] efivarfs: resyncing variable state

[  227.179633] usb usb2-port1: couldn't allocate usb_device

[  227.185648] usb usb1-port1: couldn't allocate usb_device

[  227.564995] efivarfs: finished resyncing variable state

[  227.569619] PM: suspend exit

[  227.582572] wlp1s0: deauthenticating from f0:61:c0:fb:1a:30 by local choice (Reason: 3=DEAUTH_LEAVING)

[  227.719014] qcom-ethqos 23040000.ethernet end0: Register MEM_TYPE_PAGE_POOL RxQ-0

[  227.719481] qcom-ethqos 23040000.ethernet end0: Register MEM_TYPE_PAGE_POOL RxQ-1

[  227.720092] qcom-ethqos 23040000.ethernet end0: Register MEM_TYPE_PAGE_POOL RxQ-2

[  227.720547] qcom-ethqos 23040000.ethernet end0: Register MEM_TYPE_PAGE_POOL RxQ-3

[  227.864640] qcom-ethqos 23040000.ethernet end0: PHY [stmmac-0:1c] driver [Qualcomm QCA8081] (irq=POLL)

[  227.876327] qcom-ethqos 23040000.ethernet end0: Enabling Safety Features

[  227.876525] qcom-ethqos 23040000.ethernet end0: IEEE 1588-2008 Advanced Timestamp supported

[  227.877677] qcom-ethqos 23040000.ethernet end0: registered PTP clock

[  227.877695] qcom-ethqos 23040000.ethernet end0: configuring for phy/2500base-x link mode

[  235.969916] wlp1s0: authenticate with f0:61:c0:fb:1a:30 (local address=c8:a3:e8:dd:3f:cd)

[  235.969934] wlp1s0: send auth to f0:61:c0:fb:1a:30 (try 1/3)

[  235.974836] wlp1s0: authenticated

[  235.978310] wlp1s0: associate with f0:61:c0:fb:1a:30 (try 1/3)

[  235.985386] wlp1s0: RX AssocResp from f0:61:c0:fb:1a:30 (capab=0x411 status=0 aid=4)

[  236.043409] wlp1s0: associated

[  250.895624] qcom-apm-audio-pkt gprsvc:service:2:1: CMD timeout for [1001013] opcode

[  273.379241] qcom-apm-audio-pkt gprsvc:service:2:1: CMD timeout for [1001013] opcode 