[  299.638004] PM: suspend entry (s2idle)

[  299.642907] Filesystems sync: 0.004 seconds

[  299.648758] Freezing user space processes

[  299.650269] Freezing user space processes completed (elapsed 0.001 seconds)

[  299.650276] OOM killer disabled.

[  299.650278] Freezing remaining freezable tasks

[  299.651379] Freezing remaining freezable tasks completed (elapsed 0.001 seconds)

[  299.651382] printk: Suspending console(s) (use no_console_suspend to debug)

[  301.050005] qcom-pcie 1c10000.pcie: Device not found

[  301.361474] qcom-pcie 1c00000.pcie: PCIe Gen.3 x1 link up

[  301.366284] geni_i2c 890000.i2c: Unbalanced pm_runtime_enable!

[  301.368801] geni_i2c 894000.i2c: Unbalanced pm_runtime_enable!

[  301.368815] geni_i2c a90000.i2c: Unbalanced pm_runtime_enable!

[  301.410873] ath11k_pci 0000:01:00.0: htt event 5 not handled

[  301.451536] arm-smmu 15000000.iommu: Unhandled context fault: fsr=0x402, iova=0x5a5dcd600, fsynr=0x220011, cbfrsynra=0xa0, cb=10

[  301.451548] arm-smmu 15000000.iommu: FSR    = 00000402 [Format=2 TF], SID=0xa0

[  301.451552] arm-smmu 15000000.iommu: FSYNR0 = 00220011 [S1CBNDX=34 WNR PLVL=1]

[  301.465575] xhci-hcd xhci-hcd.0.auto: WARNING: Host System Error

[  302.544742] onboard-usb-dev 2-1: device not accepting address 2, error -108

[  303.143975] onboard-usb-dev 2-1: device not accepting address 2, error -108

[  303.743814] onboard-usb-dev 2-1: device not accepting address 2, error -108

[  304.343090] onboard-usb-dev 2-1: device not accepting address 2, error -108

[  304.509158] OOM killer enabled.

[  304.509163] Restarting tasks: Starting

[  304.509629] onboard-usb-dev 1-1: USB disconnect, device number 2

[  304.509798] onboard-usb-dev 2-1: USB disconnect, device number 2

[  304.510394] Restarting tasks: Done

[  304.510405] efivarfs: resyncing variable state

[  304.512305] usb usb1-port1: couldn't allocate usb_device

[  304.518396] usb usb2-port1: couldn't allocate usb_device

[  304.634015] efivarfs: finished resyncing variable state

[  304.634620] PM: suspend exit

[  304.644838] wlp1s0: deauthenticating from f0:61:c0:fb:1a:90 by local choice (Reason: 3=DEAUTH_LEAVING)

[  304.791386] qcom-ethqos 23040000.ethernet end0: Register MEM_TYPE_PAGE_POOL RxQ-0

[  304.791773] qcom-ethqos 23040000.ethernet end0: Register MEM_TYPE_PAGE_POOL RxQ-1

[  304.792148] qcom-ethqos 23040000.ethernet end0: Register MEM_TYPE_PAGE_POOL RxQ-2

[  304.792460] qcom-ethqos 23040000.ethernet end0: Register MEM_TYPE_PAGE_POOL RxQ-3

[  304.925786] qcom-ethqos 23040000.ethernet end0: PHY [stmmac-0:1c] driver [Qualcomm QCA8081] (irq=POLL)

[  304.938255] qcom-ethqos 23040000.ethernet end0: Enabling Safety Features

[  304.938357] qcom-ethqos 23040000.ethernet end0: IEEE 1588-2008 Advanced Timestamp supported

[  304.938523] qcom-ethqos 23040000.ethernet end0: registered PTP clock

[  304.938529] qcom-ethqos 23040000.ethernet end0: configuring for phy/2500base-x link mode

[  312.586775] wlp1s0: authenticate with f0:61:c0:fb:1a:90 (local address=04:68:74:b7:1a:db)

[  312.586789] wlp1s0: send auth to f0:61:c0:fb:1a:90 (try 1/3)

[  312.592249] wlp1s0: authenticated

[  312.594410] wlp1s0: associate with f0:61:c0:fb:1a:90 (try 1/3)

[  312.600149] wlp1s0: RX AssocResp from f0:61:c0:fb:1a:90 (capab=0x411 status=0 aid=25)

[  312.646324] wlp1s0: associated 