[  301.789259] PM: suspend entry (s2idle)

[  301.792099] Filesystems sync: 0.002 seconds

[  301.797436] Freezing user space processes

[  301.798976] Freezing user space processes completed (elapsed 0.001 seconds)

[  301.798982] OOM killer disabled.

[  301.798983] Freezing remaining freezable tasks

[  301.800108] Freezing remaining freezable tasks completed (elapsed 0.001 seconds)

[  301.800112] printk: Suspending console(s) (use no_console_suspend to debug)

[  303.182838] qcom-pcie 1c10000.pcie: Device not found

[  303.494869] qcom-pcie 1c00000.pcie: PCIe Gen.3 x1 link up

[  303.500220] geni_i2c 890000.i2c: Unbalanced pm_runtime_enable!

[  303.503516] geni_i2c a90000.i2c: Unbalanced pm_runtime_enable!

[  303.503542] geni_i2c 894000.i2c: Unbalanced pm_runtime_enable!

[  303.551284] ath11k_pci 0000:01:00.0: htt event 5 not handled

[  303.592777] arm-smmu 15000000.iommu: Unhandled context fault: fsr=0x402, iova=0x5a7dcd4f0, fsynr=0x220011, cbfrsynra=0xa0, cb=10

[  303.592789] arm-smmu 15000000.iommu: FSR    = 00000402 [Format=2 TF], SID=0xa0

[  303.592794] arm-smmu 15000000.iommu: FSYNR0 = 00220011 [S1CBNDX=34 WNR PLVL=1]

[  303.606859] xhci-hcd xhci-hcd.1.auto: WARNING: Host System Error

[  304.690731] onboard-usb-dev 2-1: device not accepting address 2, error -108

[  305.291067] onboard-usb-dev 2-1: device not accepting address 2, error -108

[  305.891141] onboard-usb-dev 2-1: device not accepting address 2, error -108

[  306.490930] onboard-usb-dev 2-1: device not accepting address 2, error -108

[  306.652861] OOM killer enabled.

[  306.652865] Restarting tasks: Starting

[  306.653262] onboard-usb-dev 1-1: USB disconnect, device number 2

[  306.653527] onboard-usb-dev 2-1: USB disconnect, device number 2

[  306.654111] usb usb1-port1: couldn't allocate usb_device

[  306.654744] Restarting tasks: Done

[  306.659772] efivarfs: resyncing variable state

[  306.661133] usb usb2-port1: couldn't allocate usb_device

[  306.767918] efivarfs: finished resyncing variable state

[  306.768471] PM: suspend exit

[  306.775926] wlp1s0: deauthenticating from f0:61:c0:fb:1a:90 by local choice (Reason: 3=DEAUTH_LEAVING)

[  306.895304] qcom-ethqos 23040000.ethernet end0: Register MEM_TYPE_PAGE_POOL RxQ-0

[  306.895613] qcom-ethqos 23040000.ethernet end0: Register MEM_TYPE_PAGE_POOL RxQ-1

[  306.896070] qcom-ethqos 23040000.ethernet end0: Register MEM_TYPE_PAGE_POOL RxQ-2

[  306.896484] qcom-ethqos 23040000.ethernet end0: Register MEM_TYPE_PAGE_POOL RxQ-3

[  307.013912] qcom-ethqos 23040000.ethernet end0: PHY [stmmac-0:1c] driver [Qualcomm QCA8081] (irq=POLL)

[  307.026414] qcom-ethqos 23040000.ethernet end0: Enabling Safety Features

[  307.026528] qcom-ethqos 23040000.ethernet end0: IEEE 1588-2008 Advanced Timestamp supported

[  307.026683] qcom-ethqos 23040000.ethernet end0: registered PTP clock

[  307.026688] qcom-ethqos 23040000.ethernet end0: configuring for phy/2500base-x link mode

[  314.925697] wlp1s0: authenticate with f0:61:c0:fb:1a:90 (local address=04:68:74:b7:1a:db)

[  314.925710] wlp1s0: send auth to f0:61:c0:fb:1a:90 (try 1/3)

[  314.930071] wlp1s0: authenticated

[  314.933648] wlp1s0: associate with f0:61:c0:fb:1a:90 (try 1/3)

[  314.939907] wlp1s0: RX AssocResp from f0:61:c0:fb:1a:90 (capab=0x411 status=0 aid=7)

[  314.982957] wlp1s0: associated 