[  221.460019] PM: suspend entry (s2idle)

[  221.463930] Filesystems sync: 0.003 seconds

[  221.471265] Freezing user space processes

[  222.209418] qcom-apm-audio-pkt gprsvc:service:2:1: CMD timeout for [1001013] opcode

[  222.217953] Freezing user space processes completed (elapsed 0.746 seconds)

[  222.217968] OOM killer disabled.

[  222.217970] Freezing remaining freezable tasks

[  222.221192] Freezing remaining freezable tasks completed (elapsed 0.003 seconds)

[  222.221197] printk: Suspending console(s) (use no_console_suspend to debug)

[  223.566880] qcom-pcie 1c10000.pcie: Device not found

[  223.882914] qcom-pcie 1c00000.pcie: PCIe Gen.3 x1 link up

[  223.893666] geni_i2c 890000.i2c: Unbalanced pm_runtime_enable!

[  223.896699] geni_i2c 894000.i2c: Unbalanced pm_runtime_enable!

[  223.896707] geni_i2c a90000.i2c: Unbalanced pm_runtime_enable!

[  223.963452] ath11k_pci 0000:01:00.0: htt event 5 not handled

[  224.005025] arm-smmu 15000000.iommu: Unhandled context fault: fsr=0x402, iova=0xe4184e860, fsynr=0x11, cbfrsynra=0xa0, cb=10

[  224.005042] arm-smmu 15000000.iommu: FSR    = 00000402 [Format=2 TF], SID=0xa0

[  224.005046] arm-smmu 15000000.iommu: FSYNR0 = 00000011 [S1CBNDX=0 WNR PLVL=1]

[  224.015090] xhci-hcd xhci-hcd.0.auto: WARNING: Host System Error

[  225.102429] onboard-usb-dev 2-1: device not accepting address 2, error -108

[  225.702548] onboard-usb-dev 2-1: device not accepting address 2, error -108

[  226.302657] onboard-usb-dev 2-1: device not accepting address 2, error -108

[  226.903201] onboard-usb-dev 2-1: device not accepting address 2, error -108

[  227.082336] OOM killer enabled.

[  227.082341] Restarting tasks: Starting

[  227.083113] onboard-usb-dev 2-1: USB disconnect, device number 2

[  227.083596] Restarting tasks: Done

[  227.083607] efivarfs: resyncing variable state

[  227.084100] usb usb2-port1: couldn't allocate usb_device

[  227.087505] onboard-usb-dev 1-1: USB disconnect, device number 2

[  227.093470] usb usb1-port1: couldn't allocate usb_device

[  227.244677] efivarfs: finished resyncing variable state

[  227.245284] PM: suspend exit

[  227.262380] wlp1s0: deauthenticating from f0:61:c0:fb:79:d0 by local choice (Reason: 3=DEAUTH_LEAVING)

[  227.409353] qcom-ethqos 23040000.ethernet end0: Register MEM_TYPE_PAGE_POOL RxQ-0

[  227.409690] qcom-ethqos 23040000.ethernet end0: Register MEM_TYPE_PAGE_POOL RxQ-1

[  227.410170] qcom-ethqos 23040000.ethernet end0: Register MEM_TYPE_PAGE_POOL RxQ-2

[  227.411112] qcom-ethqos 23040000.ethernet end0: Register MEM_TYPE_PAGE_POOL RxQ-3

[  227.553847] qcom-ethqos 23040000.ethernet end0: PHY [stmmac-0:1c] driver [Qualcomm QCA8081] (irq=POLL)

[  227.566403] qcom-ethqos 23040000.ethernet end0: Enabling Safety Features

[  227.566562] qcom-ethqos 23040000.ethernet end0: IEEE 1588-2008 Advanced Timestamp supported

[  227.566753] qcom-ethqos 23040000.ethernet end0: registered PTP clock

[  227.566758] qcom-ethqos 23040000.ethernet end0: configuring for phy/2500base-x link mode

[  235.401050] wlp1s0: authenticate with f0:61:c0:fb:79:d0 (local address=04:68:74:b7:16:a7)

[  235.401069] wlp1s0: send auth to f0:61:c0:fb:79:d0 (try 1/3)

[  235.407533] wlp1s0: authenticated

[  235.410416] wlp1s0: associate with f0:61:c0:fb:79:d0 (try 1/3)

[  235.416641] wlp1s0: RX AssocResp from f0:61:c0:fb:79:d0 (capab=0x411 status=0 aid=19)

[  235.454047] wlp1s0: associated

[  250.836223] qcom-apm-audio-pkt gprsvc:service:2:1: CMD timeout for [1001013] opcode

[  273.359743] qcom-apm-audio-pkt gprsvc:service:2:1: CMD timeout for [1001013] opcode 